Bamboo Fence Rolls Halfround

To enjoy your Bamboo Fence Roll Half Round for as long as possible, it is important to mount it properly. Avoid direct contact with the ground. We recommend installing the Bamboo Fence Roll Half Round just above the ground so that it does not remain damp for long periods. After all, moisture can cause discolouration and mould over time.

To attach a Bamboo Fence Roll Half Round to a wooden fence or wall, drill 4-mm holes through the bamboo poles. Pre-drilling with a 4-mm drill is important here, as bamboo may otherwise crack. Do this every c. 20 cm and screw down the Bamboo Fence Roll Half Round with 4 x 40 mm screws. Screw the bamboo fence roll to the top and bottom for maximum stability. For fixing to a wall, plugs for the screws are often also used.

If the Bamboo Fence Roll Half Round is secured against a mesh panel, it is best to do this with tie-wraps or binding threads. These can be tied around the iron wire of the fence roll every c. 20 cm. Also in this case, fasten the bamboo fence roll at the top and bottom for maximum stability.

The width of the Bamboo Fence Roll Half Round can be easily adjusted by cutting the iron wires. After cutting the iron wires, they can be bent again. While cutting, make sure you cut two poles further than the desired width. Then remove the two outer poles from the Bamboo Fence Roll Half Round and bend the steel wires.

The height of the Bamboo Fence Roll Half Round can also be adjusted, just cut from the bottom of the fence roll and preferably not past the steel wires. This may actually make the fence roll less sturdy. When sawing the Bamboo Fence Roll Half Round, use a sharp saw blade with fine teeth, such as a Japanese Saw. Before sawing, tape the bamboo poles with strong tape on the saw edge to avoid splintering. Saw slowly and cut preferably by hand.