Bamboo Fence Rolls Regular

To enjoy your Bamboo Fence Roll Regular as long as possible, it is important that it is assembled properly. We recommend installing the Bamboo Fence Roll Regular just above ground level, so that it does not become damp for long periods of time. Moisture can cause discolouration and mould over time.

To attach a Bamboo Fence Roll Regular to a wooden fence or wall, first drill 4-mm holes through the bamboo poles. Pre-drilling with a 4-mm drill is important here, as the bamboo may otherwise crack. Do this every 20 cm or so and screw down the Bamboo Fence Roll Regular with 4 x 40 mm screws. Screw the Bamboo Fence Roll Regular to the top and bottom for maximum stability. For fixing the fence roll to a wall, plugs are often used for the screws.

If the Bamboo Fence Roll Regular is fastened to a mesh panel, it is best to do this with tie-wraps or binding threads. These can be tied around the iron wire of the fence roll every 20 cm or so. Also in this case, fasten the Bamboo Fence Roll Regular at the top and bottom for maximum stability.

The width of the Bamboo Fence Roll Regular can be easily adjusted by cutting the iron wires. While cutting, make sure to cut two poles beyond the desired width. Then remove the two outer poles from the Bamboo Fence Roll Regular and bend the steel wires again.

The height of the Bamboo Fence Roll Regular can also be adjusted, just cut from the bottom of the mat and preferably not past the steel wires. This may actually make the mat less sturdy. When sawing the Bamboo Fence Roll Regular , use a sharp saw blade with fine teeth, such as a Japanese Saw. Before sawing, tape the bamboo sticks to the saw edge to avoid splintering during sawing. Saw slowly and cut preferably by hand.